Louisiana/Iberia
300 Iberia Street, Suite 400, New Iberia, LA 70560-4543 Phone: 337-365-8246 Stormwater Management: 337-364-8474
Municipalities:
- Cities: Jeanerette | New Iberia
- Town: Delcambre
- Villages: Loreauville
- Unincorporated communities: Avery Island | Belle Place | Berard | Bob Acres | Boudreaux | Bourgeois Landing | Brannon | Bronson | Brousville | Burke | Caroline | Charlotte | Coopersville | Coteau | Daspit | Dauterive Landing | Davids | Delaware | Dennison | Deslatte | Derouen | Duboin | Emma | Fish Island | Gajan | Gall | Georgetown | Greig | Hope | Hubertville | Independent | Jefferson Island | Lasalle | Leesburg | Leleux | Lifenite | Little Valley Plantation | Loisel | Lozes | Ludger | Lyons | Marce | Masters | Mestayer | Migues | Morbihan | Nicholas | Norbert | Numa | Olivier | Oubre | Patoutville | Pesson | Port Of Iberia | Poufette | Rynella | Santiague | Segura | Sumerall | Tony | Ulyssee | Vida | Walet | Weeks
Code Of Ordinances | Assessors | GIS More Maps Zoning | Clerks of Court | Permits | Subdivision Regulations |
| Zoning | Code | Front | Sides | Rear | Lot Size | Maximum height | Sewewe & watermain info | Parking | ||
| A-1 | Agricultural District | 20' | 5' on each side from property line or ten feet between structures | 10' | At least 25 acres Smaller acreage is allowable | 32' | All board of health, sewer district, and any other applicable parish regulations must be strictly adhered to as to placement and number of dwellings. | The required parking areas for all parcels of land to be developed shall conform to the following requirements:
(1) Off-street parking areas required by this division shall be hard surfaced (asphalt or concrete) unless a variance is granted by the board of adjustment.
| ||
| R-1 | Single-Family Residential District | 20' | 5' on each side from property line or ten feet between structures | 10' | 1.
75 feet wide and a total surface area of not less than 10,000 square feet with an effluent reduction field (mechanical plant with public or community water). 2. 75 feet wide and a total surface are of not less than 12,000 square feet with an effluent reduction field (mechanical plant without public or community water). Private well must be a minimum of 50 feet from all components of sewer system. 3. 75 feet wide and a total surface area of not less than 22,500 square feet (septic tank with or without public or community water). The septic tank and all components must be a minimum of 50 feet from a water well. 4. 50 feet wide and a total surface area of not less than 6,000 square feet (private community sewer system or public sewer system with public water, community water or private well). |
32 feet (2½ floors) | Sewer and water mains shall be laid in separate trenches not less than six feet apart horizontally when installed in parallel. |
|
||
| R-2 | Mixed Residential District | 20' | 5' on each side from property line or ten feet between structures | 10' | 1.
75 feet wide and a total surface area of not less than 10,000 square feet with an effluent reduction field (mechanical plant with public or community water). 2. 75 feet wide and a total surface are of not less than 12,000 square feet with an effluent reduction field (mechanical plant without public or community water). Private well must be a minimum of 50 feet from all components of sewer system. 3. 75 feet wide and a total surface area of not less than 22,500 square feet (septic tank with or without public or community water). The septic tank and all components must be a minimum of 50 feet from a water well. 4. 50 feet wide and a total surface area of not less than 6,000 square feet (private community sewer system or public sewer system with public water, community water or private well). |
32 feet (2½ floors). | Sewer and water mains shall be laid in separate trenches not less than six feet apart horizontally when installed in parallel. | 2 spaces per dwelling unit
Two-family Dwellings |
||
| R-3 | Multi-Family Residential District | 20' | 5' on each side from property line or ten feet between structures | 10' | 1.
5,000 square feet per two-family unit (duplex). 2. 4,000 square feet for the first two units plus 1,000 square feet for each additional unit for multifamily dwellings. 3. 2,500 square feet per dwelling unit for condominiums and townhouses. 4. 3,500 square feet per dwelling unit for zero lot line homes. |
50'
Fifty feet. |
|
For multi-family residences, condominiums, townhouses, and zero lot line homes, open yard space must equal 20 percent of the lot area with the remaining 80 percent reserved for buildings and parking. | ||
| TND | Traditional Neighborhood Development | This mixed-use district must be requested and developed according to the guidelines set forth in the parish subdivision regulations. | ||||||||
|
For all building permits issued for residential, commercial or industrial construction there shall be a minimum building setback of not less than 20 feet from all road rights-of-way. |
Except where alleys are provided for the purpose, the parish council will require easements not less than ten feet in width for poles, wires, conduits or where feasible, for sanitary sewers, gas, water or other utility lines along rear lot lines and/or along side lot lines, unless the utility company certifies this to be impractical or unless it is not feasible in the opinion of the parish council. |
- Parcel or PPIN # & Flood zone information
- 911 Address
- Phone: 337-369-4427
- Recorded Deed
- Subdivision Covenants/ Restrictions
- Survey of Property
- Plotplan by a Louisiana State Licensed Engineer
- (can be obtained from original property purchase)
- Onsite Wastewater Permit
- Phone: 337-492-5540 & 337‐373‐0021 Sewage: 337-369-4413
- Temporary Power Account Number
- Firmette showing NFIP location
- FloodPlain Permit
- Flood Elevation Certificate
- elevated to or above the base flood elevation plus one foot.
- Drainage plan
- Flood Elevation Certificate
- Driveway & or Drainage Permit
- If on Highway (DOTD) – 225‐379‐1232 | Minimum size pipe of 18 inches will be utilized.
Notes: FIRM
Wind Speed Zone Requirements | Zone A Slab Regulations | Asscessory Structure in flood zone |
Non‐resident contractors must obtain a certificate of compliance
A stormwater pollution prevention plan (SWPPP) shall be submitted with the building permit application for each building permit site larger than one acre, or which forms a portion of a group of sites greater than one acre.
Storm Drainage Easements| Culvert installation procedure | Subsurface drainage will be designed to accommodate a five-year recurrent storm interval Roughness Coefficients and Manning's Formula will be utilized. A rational method for design will be used (Q = CIA). For additional information, see Chapter V of the U.S. Bureau of Public Roads Publication "Design Charts for Open Channel Flows, Hydraulic Design Series No. 3."
- The maximum grade that will be used will produce a velocity of eight feet per second.
- The minimum grade that will be used will produce a velocity of three feet per second. A minimum size pipe of 18 inches will be utilized.
- The maximum length of pipe between catchbasins and/or manholes will be:
| Pipe Size(inches) | Maximum Length(feet) |
| 18 | 300 |
| 24 and 36 | 400 |
| 42 and larger | 600 |
Minimum unobstructed private right-of-way width of 25 feet shall be required along all private streets except in the case of a private street being designated as a one-way street, in which event a minimum constructed private right-of-way width of 20 feet shall be required. If parallel parking is proposed along the private street, additional width may be required to accommodate the parking in question as determined by PW.
